Off Road Adventure

Today’s sophisticated computer controlled fuel injected engines squeeze a significant amount of horse power out of each combustion chamber.  In order to achieve their maximum output, they need precise input.  That precision involves 14.7 parts air for every 1 part fuel or 14.7:1.

How-to Clean Mass Air Flow Sensor from Hula Betty on Vimeo.

In order to know the correct amount of fuel to pump in the engine must know how much air is coming  in.  Air flow is not a constant as the rig drives down the trail, through the hot and cold as well as humid or dry conditions, enter the Mass Air Flow (MAF ) sensor. The technical jargon behind the acronym MAF involves a constant voltage passed over two heated wires placed into the airflow.  As the air flows across the the wires, they cool down creating a positive temperature coefficient (PTC).  In other words by measuring the drop in temperature of the wires (or increase in current passing through them) the engine’s computer can calculate the airflow.  To ensure a correct reading the engine’s computer takes into account temperature and humidity as well.

Eventually, dirt and oily film can cook on the wire creating a thin insulating layer of muck.  Periodically, there’s a cleaning cycle where the wires are heated to a very high temperature to burn off deposits. If the deposits remain and engine’s computer sees an air mass value out of range, it sets an error code…  and the dash board lights up like a Christmas tree.

Manufacturers of MAF sensors recommend replacing the sensor, after all they are in the business of selling them.  If you have a few garage tools and about twenty minutes you can clean the MAF sensor, which may solve the issue, if the wires are mucky between cleaning cycles.

Removing the FJ Cruiser’s MAF sensor for a visual inspection and cleaning is a simple procedure.  The first step is to remove the plastic engine cover, by loosening the two nuts up front and lifting the cover off it’s hinge.

Once cover is removed, the MAF is exposed in the front of the secondary air flow box.  Carefully, unhook the wire harness connecting the MAF to the engine’s computer.  To remove the wire harness, depress the clip and give a snug pull on the sides of the connector.  Do not pull on the wires.  If the connector refuses to release its grip, try holding the clip down while sliding a screw driver between the connector and MAF, gently prying  the two apart, careful not to apply too much force (remember plastic exposed to heat, over time can become brittle).

With the harness disconnected, remove the two screws holding the MAF in place and lift the sensor out of the the air flow box.  You can cover the opening with a shop towel to prevent any dirt, bugs or stray bird poop from falling in while you clean the sensor.

With the MAF sensor removed inspect the hot wires for muck.  In order to clean the hot wires we picked up “contact cleaner” from Radio Shack and following the directions, really read the directions… sprayed the hot wires with cleaner.

The contact cleaner we used drys in about 10 minutes and does not leave a film.  After the cleaner has done it’s job, slide the MAF back into place.  You will hear a click as it seats past the O ring on the sensor’s collar.  Screw it into place, connect the wire harness and reattach the engine cover.  Your done.

If you have an Intelligent Tester, you can ensure the mass air flow sensor is opperating within spec. following Toyota’s mass air flow service bulliten.  We simply made sure the dash board lights didn’t go into hyperdrive when we started the rig and let it warm up.

Similar 4x4 Adventure Stories and Info:

1. Eyes In The Back Of Your Rig Everyone who owns and FJ Cruiser knows how difficult it can be to judge distance when backing up.  Little cars...